acccceeeeennnnnzzzzzzzione

argomenti di tecnica in generale
Avatar utente
napolispara
Messaggi: 87
Iscritto il: mar mag 29, 2007 6:19 pm
Località: in perpetua latitanza tra vomero napoli e castellammare di stabia

acccceeeeennnnnzzzzzzzione

Messaggioda napolispara » lun mag 23, 2011 10:07 am

tutto ok paolo.... è andata benone..... lato dei consumi si sente un bel miglioramento.... prime stime in media mi dicono un miglioramento da 180 km a 205 km circa..... per quella cosa degli ohm poi ti faccio sapere.... ovviamente grazie come sempre delle lezioni interessantissime e della fantastica compagnia
La moto è un mezzo di trasporto.... ludico ma pur sempre mezzo di trasporto!
Avatar utente
Paolo
Site Admin
Messaggi: 375
Iscritto il: lun mar 26, 2007 3:42 pm
Località: Ameno Colle del Torrino
Contatta:

Messaggioda Paolo » lun mag 23, 2011 12:32 pm

sono io che ringrazio per le "provviste" divorate quasi tutte in loco ;-)
Avatar utente
napolispara
Messaggi: 87
Iscritto il: mar mag 29, 2007 6:19 pm
Località: in perpetua latitanza tra vomero napoli e castellammare di stabia

Messaggioda napolispara » lun mag 23, 2011 5:36 pm

ancora non gli ho scritto ma temo che per le bobine spinte serva un altra accensione

sulle istruzioni ho letto:

If you need this system
for use with lower Ohm coils, e.g. the Bol d’Or 3 Ohm types, you will have to order another rotor type. This is concerns the 110 contact angle type. Please mention this while ordering
La moto è un mezzo di trasporto.... ludico ma pur sempre mezzo di trasporto!
Avatar utente
napolispara
Messaggi: 87
Iscritto il: mar mag 29, 2007 6:19 pm
Località: in perpetua latitanza tra vomero napoli e castellammare di stabia

Messaggioda napolispara » mar mag 24, 2011 10:55 am

paolo, mi daresti la mail di questi?
intanto ieri ho trovato questo
http://images.cmsnl.com/shop_media/c/4/ ... _rev_b.pdf

ci sono scritte alcune cose che chiederei a mr scintilla di arezzo... tipo:

se mai dovessi avere un pacemaker non devo utilizzare la moto?

"People having pacemaker implanted should have the next steps performed by someone else. The voltage between the blue and yellow wires can rise up to 500 volts, causing the pacemaker to malfunction. The voltages at the coils side (which will not be touched normally during the installation of this kit) can reach voltages up to 40.000 Volt. This can also cause the pacemaker to malfunction. "




oppure roba di gradi.... sapete che io oltre i 90 gradi non mi spingo


"This system is developed for running with standard 5 ohm coils. If you need this system for use with lower Ohm coils, e.g. the Bol d’Or 3 Ohm types, you will have to order another rotor type. This is concerns the 110 contact angle type. Please mention this while ordering. "


* ……..your battery discharges after you have installed the SYSTEM, and did not discharge before….
You may have installed non-standard coils; 3 Ohms instead of 5 Ohms. The coils take more current, and therefore need another timing. You can order another rotor from your dealer. This rotor will provide a contact angle of 110 degrees, instead of 180 degrees. Please mention this while ordering.

oppure

* …….your coils heat up heavily after you have installed the system, and did not heat up before….
You may have installed non-standard coils; 3 Ohms instead of 5 Ohms. The coils take more current, and therefore will dissipate more heat. Also in this case the system will need another timing. You can order another rotor from your dealer. This rotor will provide a contact angle of 110 degrees, instead of 180 degrees. Please mention this while ordering.

insomma, c'è da preoccuparsi???? le mie non sono bobine del boldor.... vale lo stesso???? cambia qualcosa la faccenda dei cavi più grossi di cui parlammo????
La moto è un mezzo di trasporto.... ludico ma pur sempre mezzo di trasporto!

Torna a “Tecnico”

Chi c’è in linea

Visitano il forum: Nessuno e 1 ospite